Le mar. 20 sept. 2022 à 00:58, Feral Engineer <theferalengin...@gmail.com> a écrit :
> G96 should be able to occur the moment a tool offset is called that > produces the correct current value. That's how it works on commercial > controls. If I'm at home position in x on a Fanuc or Mitsubishi control and > ... > The spindle should start at a very low rpm, relative to the large diameter > that the X axis is located. > Considering X home is somewhere near X max, that's what I'd expect ! > There's been a bit of a learning curve with g96 in lcnc. It doesn't quite > work the way I think it would/should. > Interesting... Le mar. 20 sept. 2022 à 00:58, Feral Engineer <theferalengin...@gmail.com> a écrit : > G96 should be able to occur the moment a tool offset is called that > produces the correct current value. That's how it works on commercial > controls. If I'm at home position in x on a Fanuc or Mitsubishi control and > I do something like: > > T505 > G50S1000 > G96S175M3 > > The spindle should start at a very low rpm, relative to the large diameter > that the X axis is located. > > There's been a bit of a learning curve with g96 in lcnc. It doesn't quite > work the way I think it would/should. > > Phil T. > The Feral Engineer > > Check out my LinuxCNC tutorials, machine builds and other antics at > www.youtube.com/c/theferalengineer > > Help support my channel efforts and coffee addiction: > www.patreon.com/theferalengineer > > Order one of the coolest label makers on the market at > http://labelworks.epson.com, use coupon code "theferalengineer" and > receive > 20% off of your order 🙂 > > On Sun, Sep 18, 2022, 3:24 PM Jérémie Tarot <silopo...@gmail.com> wrote: > > > Le jeu. 15 sept. 2022 à 12:25, Nicklas SB Karlsson <n...@nksb.eu> a écrit > :. > > > > > > > > Is there any good reason surface speed should start at maximum until > > > tool is moved? Or would it be better tool does not have be moved before > > > surface speed is active? > > > > > > > > > What's the X position of the tool after tool change and the active > > work/rapid mode? > > > > Shouldn't G96 be enabled only just before lead in move? > > > > _______________________________________________ > > Emc-developers mailing list > > Emc-developers@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-developers > > > > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers > -- -- Jérémie Tarot http://about.me/silopolis _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
