Hi Phil,
Thanks for looking into this. So many seem obsessed with the Rpi4 even
though they are practically unavailable at the moment.
I started a thread on forums about possible boards we can use with links
to specs and their ups and downs.
https://forum.linuxcnc.org/18-computer/46077-potential-all-in-one-single-board-computers?start=0
preempt_rt on just about any of them is not a problem including a rk3328
board. There are even some ARM or RISC-V boards out now that have the
main processor for running Linux and a microcontroller to run Remora.
The rk3328 is a bit old right now.
https://www.libre.computer/products/roc-rk3328-cc/
https://biqu.equipment/products/manta-m4p-m8p
https://linuxgizmos.com/mangopi-allwinner-based-sbc-available-for-27us/
Lots of alternatives now.
On 11/7/22 10:08, Feral Engineer wrote:
The subject pretty much says it. I've been hammering away at a few
different raspberry pi alternative boards lately for 3d printer
applications and was wondering if anyone has any experience (or if it's
even possible) flashing the real time extensions to a sbc with a rockchip
rk3328. For reference, the board I'd like to try is the libre renegade.
Phil T.
The Feral Engineer
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers
