Hi all, Thank you very much for your comments.I have received many replies from this forum. May be someone out there can standardize this,applicable to UL,TUV,CSA etc.
On the report On the physical part VN ? ....................................... ....................................... ..................................................................... 1. Rating (V) 90-135/180-265V 115/230V NO,as this part has been tested in 90-135/180-265V range 2. Rating (I) 12/10A 10A NO,as this rating is within the tested rating 3. Rating (V) 120-127/220-240V 125/230V NO,as this part has been tested in 120-127/220-240V range 4. Rating (V) 120-127/220-240V 120-127V NO,the rating used within the tested range Once again ,thank you all and it would be good if there is standardisation made on this issue. Regards,alice ---------------------- Forwarded by Lay Siang Saw/MY/Asia/Celestica on 02/18/2003 10:51 AM --------------------------- Lay Siang Saw 02/17/2003 11:40 AM To: emc-p...@majordomo.ieee.org cc: Subject: product safety audit scenario Hi all,can anyone share with me with your comments.... Scenario : Component A with rating mentioned in the UL's product report as 90-135/180-265 Vac, however in the phyical unit is written as 115/230 V . Q1 : Is this a non conformity ? Should a VN be raised ?50 % says Yes and other 50% says No Scenario :In the report, it mentioned the marking on the label as 120-127V , however in the actual label on the unit it is written as 120-127V/220-240V. Q2. Is this a non conformity ? Should a VN be raised ?100% yes Scenario : In the report, it mentioned component B carries many safety agency certification, however i the actual physical unit, it only containes one or two safety agency logos. Q3. Is this a non conformity ? Should a VN be raised ? 90% says YES and 10% says NO Q4. When an IPI ( Initial product inspection ) is carried out, should the UL's product report been approved by the UL ? Q5. Should the report used during IPI is a detailed report with Sec general and condition of testing been included ? Q6. Can anyone share with me the correct ways the product report/FUS procedure for a product should be written so that we are not caught up with it, particularly on the rating,model and safety agency certification requirement for the product ? I am looking forwards to hearing a reply from you. Thanks Regards, alice saw This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@attbi.com For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
