Hi Charlie, It is a good reference guidance! Thanks!
Regards, Scott On 30 November 2015 at 23:08, Charlie Blackham <char...@sulisconsultants.com > wrote: > Scott > > There is a recently published draft guidance document on this Directive > that may address some of your questions: > > http://ec.europa.eu/DocsRoom/documents/13141/attachments/1/translations/en/renditions/pdf > > regards > Charlie > > -----Original Message----- > From: Scott Xe [mailto:scott...@gmail.com] > Sent: 30 November 2015 13:47 > To: EMC-PSTC@LISTSERV.IEEE.ORG > Subject: [PSES] New LV Directive 2014/35/EU > > There are 3 additional requirements as compared with existing one. > > The technical documentation shall include an adequate analysis and > assessment of the risk(s). What is objective and scope for these? Do > these analysis and assessment refer to 3rd party verification of compliance > with applicable standard(s) or are they on top of compliance with > applicable safety standard(s)? > > In DoC, a suitable identification of the product should be included - a > colour image of the product could be employed. Is there any guideline for > this product image? One exterior front view photo like one on front cover > of catalogue or a series of different views of the product? > > Article 6, point 4 regarding manufacturers’ obligations, to protect the > health and safety of consumers, carry out sample testing of electrical > equipment made available on the market. Does it mean the sample testing, > i.e.. dielectric strength test, earth continuity test, etc. is taken in > production at factory or in warehouse of destined market? > > Your guidance is highly appreciated! > > Regards, > > Scott > > - > ---------------------------------------------------------------- > This message is from the IEEE Product Safety Engineering Society emc-pstc > discussion list. To post a message to the list, send your e-mail to < > emc-p...@ieee.org> > > All emc-pstc postings are archived and searchable on the web at: > http://www.ieee-pses.org/emc-pstc.html > > Attachments are not permitted but the IEEE PSES Online Communities site at > http://product-compliance.oc.ieee.org/ can be used for graphics (in > well-used formats), large files, etc. > > Website: http://www.ieee-pses.org/ > Instructions: http://www.ieee-pses.org/list.html (including how to > unsubscribe) List rules: http://www.ieee-pses.org/listrules.html > > For help, send mail to the list administrators: > Scott Douglas <sdoug...@ieee.org> > Mike Cantwell <mcantw...@ieee.org> > > For policy questions, send mail to: > Jim Bacher: <j.bac...@ieee.org> > David Heald: <dhe...@gmail.com> > - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <emc-p...@ieee.org> All emc-pstc postings are archived and searchable on the web at: http://www.ieee-pses.org/emc-pstc.html Attachments are not permitted but the IEEE PSES Online Communities site at http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used formats), large files, etc. Website: http://www.ieee-pses.org/ Instructions: http://www.ieee-pses.org/list.html (including how to unsubscribe) List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <sdoug...@ieee.org> Mike Cantwell <mcantw...@ieee.org> For policy questions, send mail to: Jim Bacher: <j.bac...@ieee.org> David Heald: <dhe...@gmail.com>