Thanks for the info Jon. I will do some more digging on their site for the complete specs of these systems. I'm sure I will have more questions.
Reg On 9/9/07, Jon Elson <[EMAIL PROTECTED]> wrote: > Svenne Larsson wrote: > > I'm planning to use them together with a set of Rutex controllers. > > Not there yet, but in a very near future I have more to tell. :) > Oh, there will be lots more to tell, I am afraid. The Minertia > motors have extremely small inductance, as they are ironless > rotor motors. I think the circulating triangle wave current > with the unfiltered Rutex drive will be a problem. It may cause > excessive heating of the motor, drive or both. You may want to > consult with Rutex on putting an inductor in series with the > motor before you even connect it up the first time. > > Jon > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
