Thanks Gene. I hit a roadblock this weekend with the machine I wanted to use for EMC. It's an IBM ZPro, 2.88Ghz and should work. The machine has SCSI drives in it and that may be the problem. So far it's not a problem with EMC, I couldn't even get the Ubunto 6.06 Live CD to install. I may try picking up a PCI ATA disk drive today if I can't find any info here at work.
Drew Gene Heskett wrote: > Its startup curve is a bit steep. When you install, make sure you also > install an IRC client, there is a continuous presence of the developers on > freenode, /join #emc. You will usually get good answers to newbee questions > in a minute or so. For the initial config for your machine, there are > instructions in the wiki at linuxcnc.org that are pretty well spot on. > -- Drew Rogge [EMAIL PROTECTED] ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
