Forgot to say, 4 pci and a PPort, 2x ide On Wed, 2008-02-06 at 15:02 +1100, Jason Cox wrote: > G4 and up, also known as New World :) > > Jason > > On Tue, 2008-02-05 at 21:30 -0600, Chris Radek wrote: > > On Wed, Feb 06, 2008 at 12:36:08AM +0200, Alex Joni wrote: > > > This is a bit more recent: > > > https://mail.rtai.org/pipermail/rtai/2008-February/018692.html > > > > > > Regards, > > > Alex > > > > Pardon my mac ignorance but did someone say there's a model with a > > pci slot, isa slot, or parallel port? Unless one of the three is > > available there is very little point to setting up RTAI because that > > would eliminate all supported control hardware. > > > > I understand someone might want EMC2 with no hardware support for > > preview/test run purposes; if so, using the pure-userland build > > (simulator) is clearly the way to go. > > > > Chris > > > > ------------------------------------------------------------------------- > > This SF.net email is sponsored by: Microsoft > > Defy all challenges. Microsoft(R) Visual Studio 2008. > > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users >
------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users