This is an example of hooking up a MPG pendant to a second parallel port here
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Hooking_Up_A_MPG_Pendant John On 8 Jun 2008 at 23:46, Alan Condit wrote: > After you get the configuration string set. > > Do you need to add the read and write for the second port to the > base-thread? > > If yes, then what value if any needs to follow the base-thread? > > EG: > addf parport.0.read base-thread > addf parport.1.read base-thread 1 > addf stepgen.make-pulses base-thread > addf parport.0.write base-thread -1 > addf parport.1.write base-thread -1 > > > Any help greatly appreciated. > > Alan > > > ---------------------------------------------------------------------- > --- Check out the new SourceForge.net Marketplace. It's the best place > to buy or sell services for just about anything Open Source. > http://sourceforge.net/services/buy/index.php > _______________________________________________ Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users