Peter, For this project, using all three connectors is fine, it was already wired that way because of the pinout of the standard m5i20 driver. I was just hoping to eliminate one cable and the associated termination.
For my next project it would be really nice if I could get all of the I/O onto a single connector both for cost and the fact that real estate is limited. This would require 2 or 3 steppers, 1 pwm and roughly 8 inputs and 4 outputs. Everything in this case is at TTL levels so it could all come off a single connector very simply. Regards, Eric The pinout is fixed by the configuration(SVST8_4 has the pinout you see) Hostmot2 does not allow pin remapping as this uses a lot of FPGA resources The current firmware source is easy to change however, If you tell me what pinout you want, I can whip up a new bitfile in a few minutes ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
