On Fri, 5 Dec 2008, Richard Acosta wrote:
> Date: Fri, 05 Dec 2008 19:22:21 -0200
> From: Richard Acosta <[EMAIL PROTECTED]>
> Reply-To: "Enhanced Machine Controller (EMC)"
> <emc-users@lists.sourceforge.net>
> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
> Subject: Re: [Emc-users] EMC 2.2.7 + 7i43 + Ted's sample,
> and same error than using EMC 2.2.6 + 7i43 + Ted's sample.... What now?
>
> I'm (almost) sure it's the 400k version, because is the one i asked when
> i bought it, this night when in home i'll check that again.
>
This may also indicate a inability to communicate with the card.
1. Is the card jumpered for EPP (W4 and W5 both in the 'down' position)
2. Is the card powered properly (all three status LEDS = RED RED YELLOW)
Should be on at power-up
3. Is your parallel port set for EPP 1.9 mode?
4. What kind of parallel cable do you have? We have done all of our testing
with Flat cable.
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
SF.Net email is Sponsored by MIX09, March 18-20, 2009 in Las Vegas, Nevada.
The future of the web can't happen without you. Join us at MIX09 to help
pave the way to the Next Web now. Learn more and register at
http://ad.doubleclick.net/clk;208669438;13503038;i?http://2009.visitmix.com/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
