Gentlemen, now that I've got so far that my little PCB drilling machine is all set up with EMC2, she seemingly feels very uneasy. Compared to my former setup, driver board and everything being unchanged, the steppers rattle and lose steps and show all signs of maladjustment. The problem could be that I can't reduce pulse speed to less than 10 kHz (50000 ns max. in stepconfig, basic information page, step time and step space settings each). My driver board accepts only 5 kHz at max.
There must be a file somewhere containing the information that reduces the nanosecond entry to 50000 when I try to set it higher. Where can I change the max. settings of stepconfig, so I will be able to test slow puls rates? Thanks in advance Peter Blodow ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
