Hi Downloaded and compiled the above to 'run-in-place' , just to see what had changed etc. Have previously been using v2.3.0 from the cd image.
Thus far functioning as expected with one exception. When I ran a test threading file, I got an error for setting 'I0' ie thread peak = 0 This works fine under 2.3 and seems the only sane setting if you have turned down to finished diameter before threading. Since a dialog pops up that specifically says I cannot be zero, the logic has obviously changed from 2.3, but the documentation has not. I changed I to -0.001(mm) which made damn all practical difference and the code was accepted and works. The DROs showed the 0.001 has been subtracted from the X diameter in all passes. Perhaps the documentation needs to specify that 'I' must be a signed value and if the driveline is already at the thread peak, it should be adjusted by +/- I to compensate. regards Schooner ------------------------------------------------------------------------------ This SF.net email is sponsored by Make an app they can't live without Enter the BlackBerry Developer Challenge http://p.sf.net/sfu/RIM-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
