Hello All, I have reposted the below as I did not receive an email when I first posted this message to the EMC mailing list on the 2/10/10.
Cheers, SRG ------------------------------------------------------------------------------------ Hello All, I have posted details on the EMC Forum with regards to issues when using the pluto-step with at least three axis enabled. When Y is commanded feedback is seen on the Z axis which is then followed by a 'joint 2 following error' in the AXIS GUI. The pluto_inch.ini and hal files are standard and the EMC Version is 2.5.0-pre. I have also posted a HAL Scope screenshot on the forum that clearly shows the interference caused to the Z axis (Axis.2) when Y is commanded (Axis.1). Any help would be much appreciated. http://www.linuxcnc.org/component/option,com_kunena/Itemid,20/func,view/catid,38/id,4483/lang,english/ Kind Regards, SRG (Paragon) ------------------------------------------------------------------------------ Download new Adobe(R) Flash(R) Builder(TM) 4 The new Adobe(R) Flex(R) 4 and Flash(R) Builder(TM) 4 (formerly Flex(R) Builder(TM)) enable the development of rich applications that run across multiple browsers and platforms. Download your free trials today! http://p.sf.net/sfu/adobe-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users