Il 16/12/2010 16:21, Alex Joni ha scritto:
> Hi Davide,
>
> that's a question that's a bit hard to answer.
> I remember doing it, but that was around emc2 - 2.1 or even older.
> In the current versions (due to some bugfixes), I think this is prevented.
> Can't remember the reason though.
> I know it should work on the joints_axes3 branch, but that one is still in
> development/testing phase, so use with caution.
>
> Regards,
> Alex
ok i want to try to compile that branch, but since i've never done, i
just have to ask to check if i'm doing right.
i downloaded the git:
..$ git clone git://git.linuxcnc.org/git/emc2.git emc2-dev
then, entered emc2-dev directory and wrote:
..$ git checkout -b joints_axes3
Switched to a new branch 'joints_axes3'
now what?
do i have to clone the new branch, or it is already inside the directory?
sorry, it's just the first time i have to do with branches...
and then? should i compile from here? standard way?
./configure
make
make install
thank for attention. you've gained a new tester for this branch..
------------------------------------------------------------------------------
Lotusphere 2011
Register now for Lotusphere 2011 and learn how
to connect the dots, take your collaborative environment
to the next level, and enter the era of Social Business.
http://p.sf.net/sfu/lotusphere-d2d
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
