Yes, this can be done and Stuart (for one) has done it. See the wiki "Combining Two Feedback Devices On One Axis" http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Combining_Two_Feedback_Devices_On_One_Axis
Thanks, Kim On 02/16/2011 03:21 PM, Marshland Engineering wrote: > I'm not sure if this can be done but I do have it on my existing mill. > > It has servo drives with encoders but it also has encoders on the table. This > obviously gets rid of backlash. (I have to say it is very accurate mill) > > Has anyone done something like this ? > > Thanks Wallace > > > > ------------------------------------------------------------------------------ > The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: > Pinpoint memory and threading errors before they happen. > Find and fix more than 250 security defects in the development cycle. > Locate bottlenecks in serial and parallel code that limit performance. > http://p.sf.net/sfu/intel-dev2devfeb > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
