Hi all, We were diagnosing a Z-axis missing-steps issue, and noticed something interesting ... in the midst of this, we wrote some quick G-code to cycle the Z-axis up and down 10 times, and noticed that as we increased the speed, the Z-axis did not actually travel all the way to the top and bottom ends as expected, and as it did when it was run slower. Over a 4" travel range of -2" to +2", it went perhaps from -1" to +1".
I've not yet found an answer in the manuals, but is there something about EMC2's operation that would cause this? Cheers, -Neil. ------------------------------------------------------------------------------ Magic Quadrant for Content-Aware Data Loss Prevention Research study explores the data loss prevention market. Includes in-depth analysis on the changes within the DLP market, and the criteria used to evaluate the strengths and weaknesses of these DLP solutions. http://www.accelacomm.com/jaw/sfnl/114/51385063/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
