On my Hypertherm 1250 plasma table cut charts I don't see any cut speeds higher than 500IPM.
John On 10/19/2011 10:22 PM, Tom Easterday wrote: > We are mainly going to be using a plasma torch so may be cutting at 200-1000 > ipm (will be based on material and I haven't researched actual rates - but > should obviously). We would like rapids to be as fast as reasonable, and > this was part of the reason for selecting servos at all and those motors > specifically. With the current setup we will probably have rapids at 2500 > ipm. ------------------------------------------------------------------------------ The demand for IT networking professionals continues to grow, and the demand for specialized networking skills is growing even more rapidly. Take a complimentary Learning@Ciosco Self-Assessment and learn about Cisco certifications, training, and career opportunities. http://p.sf.net/sfu/cisco-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users