For those who are not familiar with the Hypertherm 1250, that plasma cutter is a beast. I used one on a production machine cutting large diameter coil springs. It is very impressive.
John, is there an EMC2 demo configuration using the Mesa THC board anywhere? I thought there used to be one in the Master?, but now I don't see it. Dave On 10/20/2011 7:31 AM, John Thornton wrote: > On my Hypertherm 1250 plasma table cut charts I don't see any cut speeds > higher than 500IPM. > > John > > On 10/19/2011 10:22 PM, Tom Easterday wrote: > >> We are mainly going to be using a plasma torch so may be cutting at 200-1000 >> ipm (will be based on material and I haven't researched actual rates - but >> should obviously). We would like rapids to be as fast as reasonable, and >> this was part of the reason for selecting servos at all and those motors >> specifically. With the current setup we will probably have rapids at 2500 >> ipm. >> > ------------------------------------------------------------------------------ The demand for IT networking professionals continues to grow, and the demand for specialized networking skills is growing even more rapidly. Take a complimentary Learning@Ciosco Self-Assessment and learn about Cisco certifications, training, and career opportunities. http://p.sf.net/sfu/cisco-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users