>>>John, is there an EMC2 demo configuration using the Mesa THC board anywhere? I thought there used to be one in the Master?, but now I don't see it.<<
Forget this request. It was right in front of me named "Plasma-5i20". Dave On 10/20/2011 11:49 AM, Dave wrote: > For those who are not familiar with the Hypertherm 1250, that plasma > cutter is a beast. > I used one on a production machine cutting large diameter coil springs. > It is very impressive. > > John, is there an EMC2 demo configuration using the Mesa THC board > anywhere? I thought there used to be one in the Master?, but now I > don't see it. > > Dave > > On 10/20/2011 7:31 AM, John Thornton wrote: > >> On my Hypertherm 1250 plasma table cut charts I don't see any cut speeds >> higher than 500IPM. >> >> John >> >> On 10/19/2011 10:22 PM, Tom Easterday wrote: >> >> >>> We are mainly going to be using a plasma torch so may be cutting at >>> 200-1000 ipm (will be based on material and I haven't researched actual >>> rates - but should obviously). We would like rapids to be as fast as >>> reasonable, and this was part of the reason for selecting servos at all and >>> those motors specifically. With the current setup we will probably have >>> rapids at 2500 ipm. >>> >>> >> >> > > ------------------------------------------------------------------------------ > The demand for IT networking professionals continues to grow, and the > demand for specialized networking skills is growing even more rapidly. > Take a complimentary Learning@Ciosco Self-Assessment and learn > about Cisco certifications, training, and career opportunities. > http://p.sf.net/sfu/cisco-dev2dev > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ The demand for IT networking professionals continues to grow, and the demand for specialized networking skills is growing even more rapidly. Take a complimentary Learning@Ciosco Self-Assessment and learn about Cisco certifications, training, and career opportunities. http://p.sf.net/sfu/cisco-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users