If you execute 'git clean -x -d -f' in top of linuxcnc source directory, it will reset to state after clone
regards Michael W dniu 17.03.2012 19:13, Viesturs Lācis pisze: > 2012/3/17 Michał Geszkiewicz<mic...@wp.pl>: >> Try use make without sudo > > Thanks, You are right, there is no sudo in wiki page. > I still get some errors, so I deleted the code, will download it again > and then retry. > > BTW a little off-topic: the command to clone the source from git is: > git clone git://git.linuxcnc.org/git/emc2.git [destination folder, I > put it in] linuxcnc-dev > > Shouldn't the renaming to LinuxCNC affect also the git? > > If I visit http://git.linuxcnc.org/gitweb, the first line still says EMC2... > > Viesturs > > ------------------------------------------------------------------------------ > This SF email is sponsosred by: > Try Windows Azure free for 90 days Click Here > http://p.sf.net/sfu/sfd2d-msazure > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ This SF email is sponsosred by: Try Windows Azure free for 90 days Click Here http://p.sf.net/sfu/sfd2d-msazure _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users