On Sat, 2012-07-21 at 17:45 +0100, andy pugh wrote:
> On 21 July 2012 17:38, Dave Keeton <[email protected]> wrote:
> > All,
> > I installed a Axiom ax5214h card in my control. Since doing this
> > the Axis GUI will not start up in my config. TKEMC runs fine. Any help
> > would be appreciated.
>
> Probably a graphics card or opengl issue, there are possible solutions
> to both issues here:
> http://wiki.linuxcnc.org/cgi-bin/wiki.pl?TroubleShooting#Display_Issues
>
Thanks! Turns out it was an active driver from my old video card
that had been removed a while back. All is good now!
Dave
------------------------------------------------------------------------------
Live Security Virtual Conference
Exclusive live event will cover all the ways today's security and
threat landscape has changed and how IT managers can respond. Discussions
will include endpoint security, mobile security and the latest in malware
threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
