G33.1 requires a spindle encoder to the best of my knowledge. I have a couple of Tapmatic NC tapping heads for non-rigid tapping that I was hoping to get to use. I hope to add a spindle encoder sometime but thought maybe I could use the Tapmatics until then.
Roger Neal -----Original Message----- From: andy pugh Sent: Saturday, May 11, 2013 5:05 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] DIY G-Code On 11 May 2013 15:31, RogerN <re...@wildblue.net> wrote: > Part of the improvement I hope to gain is spindle control, that brings me > taping capability but I read that G84 in LinuxCNC isn't implemented. I > think I could write an "O" subroutine for what I'm wanting to do but I was > hoping to figure out how to do it in C/C++ Are you sure that G33.1 isn't what you are wanting? http://www.linuxcnc.org/docs/html/gcode/gcode.html#sec:G33_1-Rigid-Tapping -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Learn Graph Databases - Download FREE O'Reilly Book "Graph Databases" is the definitive new guide to graph databases and their applications. This 200-page book is written by three acclaimed leaders in the field. The early access version is available now. Download your free book today! http://p.sf.net/sfu/neotech_d2d_may _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Learn Graph Databases - Download FREE O'Reilly Book "Graph Databases" is the definitive new guide to graph databases and their applications. This 200-page book is written by three acclaimed leaders in the field. The early access version is available now. Download your free book today! http://p.sf.net/sfu/neotech_d2d_may _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
