it is also generally more advisable to machine the center and then the outside as this will reduce chatter on the thin walled surfaces
PRIVACY NOTICE: Warning - any person and/or institution and/or Agent and/or Agency of any governmental structure including but not limited to the United States Federal Government also using or monitoring/using this website or any of its associated websites, you do NOT have my permission to utilize any of my profile information nor any of the content contained herein including, but not limited to my photos, and/or the comments made about my photos or any other "picture" art posted on my profile. You are hereby notified that you are strictly prohibited from disclosing, copying, distributing, disseminating, or taking any other action against me with regard to this profile and the contents herein. The foregoing prohibitions also apply to your employee , agent , student or any personnel under your direction or control. The contents of this profile are private and legally privileged and confidential information, and the violation of my personal privacy is punishable by law. UCC 1-103 1-308 ALL RIGHTS RESERVED WITHOUT PREJUDICES jeremy youngs On Sun, Jun 16, 2013 at 9:45 PM, jeremy youngs <jcyoung...@gmail.com> wrote: > missed steps may be andy but the interpolation segments are all pretty > short . and it is one sided . measurement of the part will tell a lot of > the story as to which side it is on . another thought is was the part held > securely? i ask because it is one sided > > PRIVACY NOTICE: Warning - any person and/or institution and/or Agent > and/or Agency of any governmental structure including but not limited to > the United States Federal Government also using or monitoring/using this > website or any of its associated websites, you do NOT have my permission to > utilize any of my profile information nor any of the content contained > herein including, but not limited to my photos, and/or the comments made > about my photos or any other "picture" art posted on my profile. > > You are hereby notified that you are strictly prohibited from disclosing, > copying, distributing, disseminating, or taking any other action against me > with regard to this profile and the contents herein. The foregoing > prohibitions also apply to your employee , agent , student or any personnel > under your direction or control. > > The contents of this profile are private and legally privileged and > confidential information, and the violation of my personal privacy is > punishable by law. UCC 1-103 1-308 ALL RIGHTS RESERVED WITHOUT PREJUDICES > > > jeremy youngs > > > On Sun, Jun 16, 2013 at 9:38 PM, andy pugh <bodge...@gmail.com> wrote: > >> On 16 June 2013 21:18, John Alexander Stewart <ivatt...@gmail.com> wrote: >> > Thanks for any words of wisdom anyone may have. >> >> I don't think that the symptoms look like this, and you would have to >> be unlucky for the system to exactly recover, but it is just possible >> that the motor slipped a few steps, then regained them. One possible >> cause for this might be the drives going into reduced current mode >> having not seen any step pulses for a sufficient time. >> >> -- >> atp >> If you can't fix it, you don't own it. >> http://www.ifixit.com/Manifesto >> >> >> ------------------------------------------------------------------------------ >> This SF.net email is sponsored by Windows: >> >> Build for Windows Store. >> >> http://p.sf.net/sfu/windows-dev2dev >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
