I need some clarification on lathe setup. The integrator manual seems to
indicate that I should remove the [axis_1] section. Some older posts say that I
will have to make a dummy 'y' axis.
I worked on ini/hal bugs/learning curve until I got Axis to appear without
crashing setup just as a mill. I then went to the lathe configuration section
of the integrators manual and did as instructed. (g 18, , lathe=1, remove [axis
1].) Now it crashes and gives me an error that the axis 2 enable out pin does
not exist. (What does axis 2 have to do with axis 1?)
Does removing the y axis mean that axis 1 is now the z axis?
Thank you,
Howard
Project lathe particulars:
Wasino L5-J2 circa 1986
12 position turret (behind spindle centerline)
DC Fanuc spindle control
Fanuc 3T yellow cap servos and drives
Mesa 5i25,7i77 (I have 5v and field power applied with flashing green light
when Axis opens successfully)
EMC 2.5
Jitter 10k to 15k ns
Started from John Thornton's sample configuration files
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
