Are you saying that it goes high during the cycle somewhere and then low again after every sequence or Low - high-low after the sequence. You may have to do a comp to time that out or ignore it if some other conditions are still met.
On 2014-04-30 09:39, Marius Alksnys wrote: > It is index enable signal. But bldc.init stops its init sequence after > axis.n.index-enable turns this signal low and it does this every single > period! > > And I can think of more cases where index-enable could be used, but it > would not be possible when it is connected to axis.n.index-enable. > > On 04/30/2014 08:00 AM, Marius Liebenberg wrote: >> It looks like it does as it is supposed to do. If that is only an enable >> signal it can be written all the time. If it was initialized correctly >> and then set by the hal config there should not be a problem with that line. >> > > > ------------------------------------------------------------------------------ > "Accelerate Dev Cycles with Automated Cross-Browser Testing - For FREE > Instantly run your Selenium tests across 300+ browser/OS combos. Get > unparalleled scalability from the best Selenium testing platform available. > Simple to use. Nothing to install. Get started now for free." > http://p.sf.net/sfu/SauceLabs > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ "Accelerate Dev Cycles with Automated Cross-Browser Testing - For FREE Instantly run your Selenium tests across 300+ browser/OS combos. Get unparalleled scalability from the best Selenium testing platform available. Simple to use. Nothing to install. Get started now for free." http://p.sf.net/sfu/SauceLabs _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
