Dave, I have a 5i20. What boards do you have attached to the 5i20?
What are you trying to do? Dave On 10/29/2014 4:00 AM, David Armstrong wrote: > Andy have you a 5i20 ? > i'm trying to add in the orient ( m19 ) can you see where i should link it > in , i have a feeling i totaly lost the plot > and trying to follow to add a mux for selecting 2 pwmgen scales for the > gearbox as i also need to operate a relay too so is a mux approprate as > you discussed > http://www.linuxcnc.org/index.php/english/forum/39-pncconf/28432-lathe-spindle-control-help-needed-in-pncconf?start=20 > and becoming confused in the process , probably because i'm using a 5i20 > and not a 5i25 which i'm more familiar with > > full config folder attached if it make it easier to open > > i have 2 pwmgen scales which are halcmd setp pwmgen.scale -5950 ( high > range and default ) > and > low range halcmd setp pwmgen.scale -1550 > along with a gpio pin to select true at the same time as this scale > halcmd setp hm2_5i20.0.gpio.069.out > > if you haver a few mins Andy guide me out of this maze and correct me on > the path to enlightenment > as i'm sure iv'e mucked up somewhere > > > > > > > On 28 October 2014 23:46, andy pugh <bodge...@gmail.com> wrote: > >> On 28 October 2014 22:32, andy pugh <bodge...@gmail.com> wrote: >> >>> Thanks, that works a treat. >> Bah! Within limits anyway. >> >> I have ended up with a GtkEntry that has both icons active as up and >> down buttons. Looks good for touchscreen use. >> But I can't figure out how to get the icons to operate and also have >> the pop-up keyboard come up when something other than the icons is >> pressed. >> >> The whole widget responds to button_click, and the click-position is >> relative to the icon or the text entry, so no way to distinguish the >> icons from each other, or the left-hand edge of the text from either >> icon. >> >> >> -- >> atp >> If you can't fix it, you don't own it. >> http://www.ifixit.com/Manifesto >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> >> >> >> ------------------------------------------------------------------------------ >> >> >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users