Hey Guys,
I will start from the top on what I have done,
I have Debian built from the boo-table USB from the website, then I
compiled using,
cd ~
sudo apt-get install git-core gitk git-gui
sudo apt-get build-dep linuxcnc
sudo apt-get install linux-image-3.2.0-4-rt-686-pae
sudo apt-get install libudev-dev
sudo apt-get install iptables-persistent
git clone git://git.linuxcnc.org/git/linuxcnc.git linuxcnc-dev
cd linuxcnc-dev
git pull
git checkout master
cd src
./autogen.sh
./configure --with-realtime=uspace
make
sudo make setuid
After that is when I tried to load the firmware to the card, then I
tried to change the card IP address, both times I get the "No 7I80 board
found"
Then I found in the HM2_ETH manual the following entries,
*Configure network with static address*
Add these lines to the file /etc/network/interfaces to configure eth1
with a static address:
auto eth1
iface eth1 inet static
address 192.168.1.1
*Disable IPv6 on the dedicated interface*
By default, Linux may transmit IPv6 packets on all interfaces, even if
they are not explicitly configured with global IPv6 addresses. In
/etc/sysctl.conf, disable ipv6 on eth1 by adding this line:
net.ipv6.conf.eth1.disable_ipv6=1
*Note:*Simply setting ’ipv6’ to ’ignore’ in the GUI network tools does
not eliminate the link-local ipv6 address. Use the sysctl.conf method
even if you otherwise use the GUI to configure the dedicated interface.
*Configure iptables for exclusive access*
Install the package "iptables-persistent" and put this in the file
/etc/iptables/rules.v4 (remove leading whitespace from every line):
*filter
:OUTPUT ACCEPT [0:0]
:hm2-eth-rules-output - [0:0]
-A OUTPUT -j hm2-eth-rules-output
COMMIT
Of which I did all of the above, and still I get the "No 7I80 board
found" after trying to communicate with the board.
I am using the following MB,
http://www.asrock.com/mb/AMD/FM2A88X-ITX+/?cat=Specifications only
because we have had very good luck with the ASrock boards, and this
offered on-board WiFi, to get around the problem of not having an
ethernet port to connect to our network, when using the 7i80.
Could the on-board WiFi be causing my communication problem?
--
Thanks
Rick Lair
Superior Roll & Turning LLC
399 East Center Street
Petersburg MI, 49270
PH: 734-279-1831
FAX: 734-279-1166
www.superiorroll.com
------------------------------------------------------------------------------
BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT
Develop your own process in accordance with the BPMN 2 standard
Learn Process modeling best practices with Bonita BPM through live exercises
http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_
source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
