I uncommeted the loopback and it works. Thanks JT
On 4/8/2015 6:49 AM, Andreas Pettersson wrote: > Ah you still need the loopback interface (the lo interface) you just add > ontop of the existing config. > > The old 3Com Tornado/Boomerang cards isnt always supported out of the > box actually. > But you can try to change the eth0 to eth1 and see if it sits on a > different device. > > Otherwise i would suspect you need to compile a driver. =) > > // Andreas > > John Thornton skrev den 2015-04-08 13:42: >> I commented out the original lines and added the second then rebooted >> and no network. >> >> lspci reports: Ethernet Controller 3Com Corporation 3c905C-TX/TX-M >> [Tornado] (rev78) >> >> JT >> >> On 4/8/2015 6:31 AM, Andreas Pettersson wrote: >>> So you dont have a a eth0 at all. then you need to add something like this. >>> >>> allow-hotplug eth0 >>> iface eth0 inet static >>> address 192.168.1.150 >>> netmask 255.255.255.0 >>> broadcast 192.168.1.255 >>> gateway 192.168.1.1 >>> >>> OR!! >>> >>> allow-hotplug eth0 >>> iface eth0 inet dhcp >>> >>> depending on your network of course if you have a router with dhcp/dns >>> you use the second one if not you need to staticly configure. >>> >>> // Andreas >>> >>> >>> John Thornton skrev den 2015-04-08 13:26: >>>> etc/network/interfaces contains two lines: >>>> auto lo >>>> iface lo inet loopback >>>> >>>> JT >>>> >>>> On 4/8/2015 6:17 AM, Andreas Pettersson wrote: >>>>> You would prob. need to activate the card in the config. >>>>> You will find the config file under /etc/network/interfaces >>>>> >>>>> Prob. is the pci card on eth1 instead of eth0 - even if its deactivated >>>>> in the bios. >>>>> it usually "adresses" it self, just not useable. >>>>> >>>>> // A >>>>> >>>>> John Thornton skrev den 2015-04-08 13:12: >>>>>> I have a Debian Wheezy install on a computer down here in the Beer Cave >>>>>> and the other day the power blinked and I lost network connectivity on >>>>>> that computer. After some fumbling around I see that I had a red light >>>>>> on the router for that line instead of a green one. So I put a network >>>>>> card in the PCI slot and plugged that in. Now I have a green light on >>>>>> the router. I went to the bios and turned off the Ethernet on the >>>>>> motherboard. I still don't have a connection to the LAN from that >>>>>> computer. Any clues as to what I need to do? >>>>>> >>>>>> Thanks >>>>>> JT >>>>>> >>>>>> ------------------------------------------------------------------------------ >>>>>> BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT >>>>>> Develop your own process in accordance with the BPMN 2 standard >>>>>> Learn Process modeling best practices with Bonita BPM through live >>>>>> exercises >>>>>> http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- >>>>>> event?utm_ >>>>>> source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF >>>>>> _______________________________________________ >>>>>> Emc-users mailing list >>>>>> Emc-users@lists.sourceforge.net >>>>>> https://lists.sourceforge.net/lists/listinfo/emc-users >>>>> ------------------------------------------------------------------------------ >>>>> BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT >>>>> Develop your own process in accordance with the BPMN 2 standard >>>>> Learn Process modeling best practices with Bonita BPM through live >>>>> exercises >>>>> http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- >>>>> event?utm_ >>>>> source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF >>>>> _______________________________________________ >>>>> Emc-users mailing list >>>>> Emc-users@lists.sourceforge.net >>>>> https://lists.sourceforge.net/lists/listinfo/emc-users >>>> ------------------------------------------------------------------------------ >>>> BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT >>>> Develop your own process in accordance with the BPMN 2 standard >>>> Learn Process modeling best practices with Bonita BPM through live >>>> exercises >>>> http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ >>>> source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF >>>> _______________________________________________ >>>> Emc-users mailing list >>>> Emc-users@lists.sourceforge.net >>>> https://lists.sourceforge.net/lists/listinfo/emc-users >>> ------------------------------------------------------------------------------ >>> BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT >>> Develop your own process in accordance with the BPMN 2 standard >>> Learn Process modeling best practices with Bonita BPM through live exercises >>> http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ >>> source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF >>> _______________________________________________ >>> Emc-users mailing list >>> Emc-users@lists.sourceforge.net >>> https://lists.sourceforge.net/lists/listinfo/emc-users >> ------------------------------------------------------------------------------ >> BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT >> Develop your own process in accordance with the BPMN 2 standard >> Learn Process modeling best practices with Bonita BPM through live exercises >> http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ >> source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ > BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT > Develop your own process in accordance with the BPMN 2 standard > Learn Process modeling best practices with Bonita BPM through live exercises > http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ > source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
