On the Tormach mailing list there was a report of the same error caused by having a M09 and M30 on the same line. Is it possible that this is a related problem?
> -----Original Message----- > From: Rick Lair [mailto:r...@superiorroll.com] > Sent: Wednesday, July 15, 2015 10:54 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Bug:Call Stack Under run > > Hello Seb, > > I have been working on this all week, I have run this program numerous times > on my simulator test PC in my office without any issue, as soon as I try to run it > on the machine, it gives us this fault. This morning I made a new config using > the Axis GUI, and it gives us the same fault, (we are running Gmoccapy on our > turning centers, and wanted to make sure it wasn't a GUI issue). > > The only thing different between my test PC, and the machines are the added > m-codes for the gear change, and for the tail stock commands, and we use the > TXXYY tool change format on the lathes, so I modified the g-code program to > eliminate the m-codes for the gear change, and tailstock, and change the tool > changes to the MxTy format. > > The M-codes, and tool change work fine through MDI, and with other > programs, so I don't think that is the issue. The supervisor has removed > different sections of the program, and it will run, he puts them back in, and it > won't run, > > It doesn't matter which section he removes though ( no one section would > specifically give or not give the fault ), the only thing we have found was > program size made a difference, The main program is 367 lines long > 6736 KB's, if it was kept under about 260 lines, or 5KB's > > Attached is the program we are dealing with, the file ending in rev2 is what I > am using on my test PC. > > > Thanks > > Rick > > On 7/10/2015 6:04 PM, Sebastian Kuzminsky wrote: > > On 7/10/15 3:43 PM, Jeff Johnson wrote: > >> I have a program with threading G33 that will run if I take the threading > >> out of it but throw an error of "Bug: Call Stack Under Run" if I leave the > >> threading in the program. We use a post processor for our programs and > have > >> done threading in the past but this one is persistent. Any Ideas? > > Can you reproduce the problem by running the problematic gcode in a > > standard sim config? > > > > > > -- > > Thanks > > > Rick Lair > Superior Roll & Turning LLC > 399 East Center Street > Petersburg MI, 49270 > PH: 734-279-1831 > FAX: 734-279-1166 > www.superiorroll.com ------------------------------------------------------------------------------ Don't Limit Your Business. Reach for the Cloud. GigeNET's Cloud Solutions provide you with the tools and support that you need to offload your IT needs and focus on growing your business. Configured For All Businesses. Start Your Cloud Today. https://www.gigenetcloud.com/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users