On 06.09.15 05:56, Stuart Stevenson wrote: > > "Unfortunately, LOCTITE anaerobic products (like the 680) can only be > > used on metal surfaces. Zirconia is a non metal (i.e. ceramic) and a > > Primer is not suitable for this application." > > > > Wouldn't this be good information to use if you wanted to build up a > shaft/bore? > You could use a non metal that should be easily removable?
Hadn't thought of that, but the info sheet mentioned upthread claims upgraded 680 to be 100% the strength of steel for a 0.05 mm gap, reducing to ~65% for a 0.25 mm gap. Some folk build precision machines by whacking through slightly oversized holes in a frame, then epoxying bearings in place already mounted on their shaft, which is precision jigged in place, so your approach might work for a small build-up, I figure. Erik ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
