> -------- Original Message -------- > Subject: Re: [Emc-users] Carousel Component > From: andy pugh <[email protected]> > Date: Fri, October 30, 2015 1:22 pm > To: "Enhanced Machine Controller (EMC)" > <[email protected]> > > > On 30 October 2015 at 16:10, Rick Lair <[email protected]> wrote: > > I don't have the dev package installed, I just downloaded it, to get to > > the remap stuff. > > There is scope for confusion here. linuxcnc-dev is a package that can > be downloaded from the package manager, either through the synaptic > gui or with > sudo apt-get install linuxcnc-dev >
I am getting an error trying this ^^, Here is the error, greenmill@greenmill:~$ sudo apt-get install linuxcnc-dev [sudo] password for greenmill: Reading package lists... Done Building dependency tree Reading state information... Done Package linuxcnc-dev is not available, but is referred to by another package. This may mean that the package is missing, has been obsoleted, or is only available from another source E: Package 'linuxcnc-dev' has no installation candidate greenmill@greenmill:~$ Is this because of running uspace? Rick > However, if you download the LinuxCNC source code, that generally ends > up on a folder also called linuxcnc-dev. But you can have either one > without the other. > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
