[Note: resending because I did not receive a copy from the list distribution; I apologize for any duplicates]
Greetings, Long story short; I had to install a new PCI Parport card and I am trying to figure out what address to use for my hal configuration file for Axis. The card has the same CH382L chip listed in the wiki: http://wiki.linuxcnc.org/cgi-bin/wiki.pl?WCH lspci shows it as: 04:00.0 Serial controller: Device 1c00:3050 (rev 10) (prog-if 05 [16850]) Subsystem: Device 1c00:3050 Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin A routed to IRQ 18 Region 0: I/O ports at d000 [size=256] Region 1: Memory at d0000000 (32-bit, prefetchable) [size=32K] Region 2: I/O ports at d100 [size=4] Expansion ROM at fb300000 [disabled] [size=32K] Capabilities: <access denied> I tried using the addresses d000 and d100 etc, but those don’t seem to work. Last card I has I had to run: sudo ./showport C030 C020 e But I am not sure if I need to, or what address range to use for it. Cheers, Jeshua Lacock Founder/Engineer <3DTOPO.com> GlassPrinted.com ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
