thats exactly the cards i have here Andy if you want a bin full , i can send you a few more !
On 20 November 2015 at 18:46, andy pugh <bodge...@gmail.com> wrote: > On 18 November 2015 at 17:49, Jeshua Lacock <jes...@3dtopo.com> wrote: > > Long story short; I had to install a new PCI Parport card and I am > trying to figure out what address to use for my hal configuration file for > Axis. The card has the same CH382L chip listed in the wiki: > > > > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?WCH > > It isn't clear to me what that Wiki page is for. It doesn't say that > it works. It doesn't say that it doesn't work. > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > -- The information contained in this message is confidential and is intended for the addressee only. If you have received this message in error or there are any problems please notify the originator immediately. The unauthorised use, disclosure, copying or alteration of this message is strictly forbidden. This mail and any attachments have been scanned for viruses prior to leaving the RcTechnix network. RcTechnix will not be liable for direct, special, indirect or consequential damages arising from alteration of the contents of this message by a third party or as a result of any virus being passed on. RcTechnix reserves the right to monitor and record e-mail messages being sent to and from this address for the purposes of investigating or detecting any unauthorised use of its system and ensuring effective operation. (c) RcTechnix ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
