On Saturday 12 March 2016 20:34:55 Gene Heskett wrote: > Greetings everyone; > > I noted that at the bottom in the (sim) axis.ini, three entries for > some tool changer presets, like TOOL_CHANGE_POSITION etc. So I copied > them to the 2.8.0pre2-yadda on the GO704's axis.ini. > > WHat I want to do is to have it use that data IF its going to cgange > the tool, or ignore it if the tool is already loaded. So I expected > it to work, and put a comment () around the G0 Z5 that I normally > preceed an upcoming tool change. It was ignored, and I wound up > looking at the please load tool 2 requestor, with the tool sitting at > Z0.1. So I hit the esc key and put that G0 Z5 line active again. > Since my Z can't go any faster than 40 IPM, that, if the tool is > already loaded, is about 20 seconds of time wasted running up the post > and back down again. > > Is there some other magic incantation to make that work that I got > stoned (high sugar) on a bowl of ice cream and missed the memo about > it? > > Thanks for any hints. > > Cheers, Gene Heskett
I just found some notes in the wiki indicating that stuff was supposed to be in the [EMCIO] section, so I moved them, and will test tomorrow. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Transform Data into Opportunity. Accelerate data analysis in your applications with Intel Data Analytics Acceleration Library. Click to learn more. http://pubads.g.doubleclick.net/gampad/clk?id=278785111&iu=/4140 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
