On 01/22/2017 08:40 AM, Peter Blodow wrote: > Never touch a running system. > Peter > > Am 21.01.2017 20:24, schrieb Gene Heskett: >> Greetings everybody. >> >> My 3 jaw chuck atm, runs pretty true. But to be able to turn the >> faceplate around and clean up the OD of the hub for a grab surface for >> my clamp concoction so it can't unscrew itself during a violent >> reversal, I'll have to remove the chuck, removing its 5.16" socket cap >> screws. >> >> Whats my chances of getting it remounted so it runs true again once I >> have made a 2 or 3 thou cleanup cut on the rear hubs OD with the the >> faceplate reversed on the spindle? >> >> Cheers, Gene Heskett > If I had to remove and replace the chuck I would run a dial indicator on the OD back edge and back face near the OD and write the numbers on those spots on the chuck. If it does not remount to those indications then it is the work to move it or shim it until it does.
Ed. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
