On Sunday 22 January 2017 10:53:30 Ed wrote: > On 01/22/2017 08:40 AM, Peter Blodow wrote: > > Never touch a running system. > > Peter > > > > Am 21.01.2017 20:24, schrieb Gene Heskett: > >> Greetings everybody. > >> > >> My 3 jaw chuck atm, runs pretty true. But to be able to turn the > >> faceplate around and clean up the OD of the hub for a grab surface > >> for my clamp concoction so it can't unscrew itself during a violent > >> reversal, I'll have to remove the chuck, removing its 5.16" socket > >> cap screws. > >> > >> Whats my chances of getting it remounted so it runs true again once > >> I have made a 2 or 3 thou cleanup cut on the rear hubs OD with the > >> the faceplate reversed on the spindle? > >> > >> Cheers, Gene Heskett > > If I had to remove and replace the chuck I would run a dial indicator > on the OD back edge and back face near the OD and write the numbers on > those spots on the chuck. If it does not remount to those indications > then it is the work to move it or shim it until it does. > > Ed. > Point taken, thanks Ed. > ---------------------------------------------------------------------- >-------- Check out the vibrant tech community on one of the world's > most engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
