https://shop.vhf.de/catalogs/Thread-cutters-W_GW.htm
https://shop.vhf.de/articleGroups/Circular-thread-cutters-W_GW_BGF.htm I am very fond of the one above = 2 tools in 1 Cheers Bengt Den 2017-02-03 kl. 12:46, skrev Valerio Bellizzomi: > On Fri, 2017-02-03 at 11:28 +0000, andy pugh wrote: >> On 3 February 2017 at 11:19, Valerio Bellizzomi <vale...@selnet.org> wrote: >>> With this interpolated motion there is no need for spindle reversal when >>> tapping >> Yes, but, unless there is something very clever going on in those >> animations, you need a cutting tool with zero lead. >> I am about 80% convinced that you can#t do it with a standard tap. >> >> >> > > It needs a special tool > > http://www.infodelta.it/foto/Filettatura%20interpolata.jpg > > > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users