On Wed, 2017-02-15 at 22:57 +0200, Andrew wrote:
> 2017-02-15 22:46 GMT+02:00 Valerio Bellizzomi:
> 
> >
> > Thanks, I just placed an order
> >
> > btw, my spindle does not have an encoder so I will not do threading and
> > I do not need a 'reverse' signal, only a 'forward' signal, and the
> > enable signal is going to be wired together with axis enable and
> > connected to the Amplifier Enable pin, so that a single amplifier enable
> > signal commands the axes and spindle.
> >
> 
> I'm not sure why you want to wire them together. There are many situations
> when I want my axes enabled but spindle disabled.


it is only a question of space, if I have enought pins left empty I
could wire them separately




------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to