I was trying to convert one of my machine configs to test with Master. Testing in a VM.
I've ran into a couple of snags though. The machine uses 3 parallel ports, two of them in X-mode, and one as Out. When I try to run the config I get: Error: could not insert module /usr/realtime-3.4-9-rtai-686-pae/modules/linuxcnc/hal_parport.ko: No such device And if I try to convert the config to use sim_parport, I get: ./Dig1.hal:73: Pin 'parport.0.pin-01-in-not' does not exist So apparently my VM won't start a config with 3 parallel ports (it will start the demos with only 1). And sim_parport doesn't work with X-mode parallel port configurations. Any suggestions? -- ======================================== Todd Zuercher mailto:[email protected] ======================================== ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
