On 06/01/2017 01:22 PM, Todd Zuercher wrote:
I was trying to convert one of my machine configs to test with Master. Testing
in a VM.
I've ran into a couple of snags though. The machine uses 3 parallel ports, two
of them in X-mode, and one as Out.
When I try to run the config I get:
Error: could not insert module
/usr/realtime-3.4-9-rtai-686-pae/modules/linuxcnc/hal_parport.ko: No such device
Do you have three parallel ports enabled on your VM? Does the linux
parport driver see them?
--
Sebastian Kuzminsky
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
