Thanks Andy, I made a new component (sim_parport2) and that seemed to work. Perhaps someone should put a revised version of sim_parport in the main release.
----- Original Message ----- From: "andy pugh" <bodge...@gmail.com> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: Thursday, June 1, 2017 3:56:07 PM Subject: Re: [Emc-users] Simulations In Master? On 1 June 2017 at 20:22, Todd Zuercher <zuerc...@embarqmail.com> wrote: > Any suggestions? It's a very simple comp. https://github.com/LinuxCNC/linuxcnc/blob/master/src/hal/components/sim_parport.comp So adding the extra pins needed should be trivial. (I can't help feeling that it could be an awful lot shorter too, using the pin in bit pin_##_in [15] format and just living with there being some pins that don't actually exist) -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users