> On 07/19/2017 08:26 AM, Nicklas Karlsson wrote: > > I have arrived at a point there I am starting to think about > > splitting linuxcnc in two, one for real time and the other for GUI. I > > know it have been up before not to long time ago. I guess move EMCMOT > > and below is what I start with but EMCTASK I am a little bit unsure > > about. > > > > Do anybody have experience of suggestions for this? > > LinuxCNC already is split this way, though in practice almost(?) > everyone runs the realtime part and the non-realtime part on the same > machine.
I have should have looked before talking and found the linuxcnc is actually a script. In process list I could see io,linuxcncsvr and milltask so I guess several tasks are started. Will eat my way thru and try to figure out what is happening. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
