It has no CPU unless you build one from cells. There are soft cores available. This is an add on card like mesa without any pci or ethernet _yet_.
On Oct 14, 2017 7:22 PM, "Nicklas SB Karlsson" <nicklas.karlsso...@gmail.com> wrote: > A circuit with a reasonable fast CPU, Ethernet and the FPGA for an > arbitrary number of communication ports, UART, SPI, CAN would probably be > the ideal device for a linuxcnc server. > > I read fast and can't figure out the CPU on this chip. > > On Sat, 14 Oct 2017 18:05:52 +0700 > TJoseph Powderly <tjt...@gmail.com> wrote: > > > Has anyone looked at 'arty' for linuxcnc/hal? > > http://rdepablos.merlitec.com/arty-and-linux-1-fpga . its nice to get > the > > whole toolset with it inside 100$US. > > > > Regards Tomp tjtr33 > > ------------------------------------------------------------ > ------------------ > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
