> ... > > It might be a good idea to turn by hand and check if load is same in > > both direction. To run motor without load in both directions is also a > > good idea. > > From the hand on the spindle test, or from the top of the tight drawbolt > it turns with equal ease in both directions.
Then I think to check voltage is same in both directions is next step. On my first machine at home one of the joints is very hard to turn by hand. There are basically sliding surfaces so not much could be wrong but it still pussle me how I should pin point the problem, any idea? ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
