On 11/27/2017 02:49 PM, andy pugh wrote:
On 27 November 2017 at 20:40, Gene Heskett <ghesk...@shentel.net> wrote:
But thats not the /real/ pita. Parport pin 14 is not on the i/o terminals
its apparently spindle motor relay control, and on a 5i25, is the pwm
signal from the 5i25's pwmgen.0.
Did you consider looking for a firmware with a pinout to suit the board?
Those white 4 pin plugs fairly scream for a matching cable to be plugged
in as opposed to using the green screw terminals, because to use those
I'll have to open them with a prybar as I have yet to get a wire smaller
than 16 gauge to force its way into that style of terminal, when the
leaf, driven by the screw, is already pre-bent into the closed position
Have you tried bootlace ferrules?
Try automation direct. Many sizes...
Dave
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
