On Tuesday 28 November 2017 14:40:50 dave wrote: > On 11/27/2017 02:49 PM, andy pugh wrote: > > On 27 November 2017 at 20:40, Gene Heskett <ghesk...@shentel.net> wrote: > >> But thats not the /real/ pita. Parport pin 14 is not on the i/o > >> terminals its apparently spindle motor relay control, and on a > >> 5i25, is the pwm signal from the 5i25's pwmgen.0. > > > > Did you consider looking for a firmware with a pinout to suit the > > board? > > > >> Those white 4 pin plugs fairly scream for a matching cable to be > >> plugged in as opposed to using the green screw terminals, because > >> to use those I'll have to open them with a prybar as I have yet to > >> get a wire smaller than 16 gauge to force its way into that style > >> of terminal, when the leaf, driven by the screw, is already > >> pre-bent into the closed position > > > > Have you tried bootlace ferrules? > > Try automation direct. Many sizes... > > Dave > I am about 90% complete, so its getting mooter and mooter.
Thanks Dave. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
