On Tue, Apr 24, 2018, 14:38 Peter C. Wallace <[email protected]> wrote:
> On Tue, 24 Apr 2018, jeremy youngs wrote: > > > Date: Tue, 24 Apr 2018 19:17:40 +0000 > > From: jeremy youngs <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: "Enhanced Machine Controller (EMC)" <[email protected] > > > > Subject: Re: [Emc-users] 7i90 not listed in pnc > > Before you change anything on the 7I90, > I have no intent at this time to change anything, just to communicate with it and begin sorting what I need to make it run. > > How do you intend to use the 7I90HD? > I am intending 3 DC brush servo with generic pwm speed and direction control. One analog spindle amp at this time. The eventuality is 2 analog spindle , one as a lathe on my mill bed. I have another epp card as well if more I/o is necessary, I had read the softdmc manual and was quite interested in using that to drive the generic hbridge, but apparently it's a histmot2 function in linuxcnc. This is my first experience with any smart board interaction so pleas excuse my ignorance. I have read quite a bit of the lcnc manual and the 7i90 he manual. And I seem to be blind to a set of step by step directions.i see the 7i90 primary function as handling the encoder, if hostmot2 allows pid adjustments that would be awesome, although more to learn. > > What host computer are you planning to use? > > Dell optiplex 620 2.8 GHz duo core , 4gb ram , running through the > motherboard epp as I had seen a couple post you made on the forum about pci > boards being sketchy, although I have had no issues running stepper drives > with it. It should be noted, I updated this lcnc install 2 months ago and > the system has been in use for years as an epp- stepper system. > Thank you for your time , Peter and Gene > > > 7i90 zip extracted to public folder. Invocation of mesaflash says no > > program to open it . Tried the mesaflash icon and the mesaflash 3 icon. > How > > do I know what dependencies are required to run this. V 2.7 11? Installed > > > ------------------------------------------------------------------------------ > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
