If you are in the UK or EU it's not such a big deal since the power isn't split phase 110/220 VAC. PCs, monitors etc are all configured for 220/240 VAC input as would be your Mill. That means the CNC side is also probably powered from the same 220/240VAC circuit.
But for North America we have split phase. My Mill was wired for 220VAC in and has a small transformer (120VAC, 24VAC) to run the power feed and relay logic. The split isn't wired nor does the switch and contactor handle this. I could run a 250VA Step down transformer to create 110VAC for the PC and Monitor (0.8A + 1.7A) or just run them both off 220VAC switched from the same master switch that runs the mill. What are others in North America doing for powering their PCs and Monitors? Separate AC outlet/power bar for the PC? Thanks John ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users