On Sat, Aug 11, 2018, 3:32 PM Gene Heskett <ghesk...@shentel.net> wrote:
> On Saturday 11 August 2018 15:24:17 Ken Strauss wrote: > > > I was also curious and found > > https://www.motioncontroltips.com/faq-why-are-so-many-designers-replac > >ing-re solvers-with-encoders/ > > Some excellent discussions there Ken, thank you. > > One thing that was mentioned in another page there but only in passing > was ptfe (teflon) in re sliding ways surfaces, > https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F263619540144 I have been using this . I also milled slots in ways and used typar to fill slots , the tape is much easier and the give need less material removal for proper clearance when done. As to longevity of tape , I haven't used it long , so the verdict is out , it makes a big difference though. > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
