The first thing I would check is what subroutine are you calling. Since this is immediately after an update you may be calling an old subroutine without the G43 line.
On Sat, Aug 25, 2018, 4:18 AM Les Newell <[email protected]> wrote: > Yes there is but I was actually paying attention to the tool length > rather than diameter. I generally do diameter compensation in cam rather > than the control. > > Les > > On 24/08/18 23:24, jeremy youngs wrote: > > Is there a g40 in your prep line ? > > > > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
